Tenergy 01005 Smart Universal Charger for NiMH / NiCd Battery pack 7.2V - 12V with charging current SelectionFeatures and Benefits:
- Best Charger for charging all RC Car, RC air and Airsoft battery packs 7.2V, 8.4V, 9.6V and 12V.
- For 2000mAh pack, charging time is approximately 3 hours. (Charging at 0.9A)
- For 3000mAh pack, charging time is approximately 2 hours. (Charging at 1.8A)
- Universal for for any NiMH /NiCd battery packs 7.2V - 12V (6-10 Cells pack)
- Fast charger with current switch to select either, 0.9A and 1.8A. Deliver full charge within 1 - 3 hours.
- Charging Current 0.9A for battery packs with capacity from 1100mAh -2200mAh.
- Charging Current 1.8A for battery packs with capacity above 2000mAh.
- Smart Charger with automatic voltage detection.
- Use pulse and negative pulse technology to avoid battery overheating during fast charging, optimized for battery pack's cycle life.
- Red LED will be on during charging.
- Automatically charging ending with negative delta V.
- Worldwide usage with 120-240V AC
- Safety protection fuse for over current, short circuit & reverse polarity protection.
- Manufacturer's Part Number: 01005
Smart Charger Specifications:
- 1 standard Tamiya Female connector and Fuse house with the smart battery charger.
- 1 connector adaptor from standard Male Tamiya to Mini Female.
- 1 set of clip adaptor with Male Tamiya connector on one end.
- 4 additional fuses
- FOR 6V-12V NI-MH/NI-CD BATTERY PACK 6-10PCS BATTERY
- Input: AC100-240V
- Output: 6-12V 0.9or1.8A
- Connect battery pack to output connector and plug AC power source.
- Make sure battery polarity is connected correctly (Red wire is positive)
- Charger will detect battery voltage automatically, Red LED will be on during charging
- When battery is fully charged, current will reduce to trickle charging at 50mA,Green LED will be on
- Battery will be charged at 0.9A or 1.8A constant current
- Approximate Charging time is about 1.5hrs for 3000mAh battery,1hr for 1800mAh battery.
- The charger is designed for faster charging NiCd and NiMH battery packs from 6 to 12V for RC car/Air and Air soft gun.
- Don't charger battery pack with voltage less than 6V or Voltage bigger than 12V and Capacity smaller than1100mAh.
- Battery pack must be made by high drain current cell.
- Please contact your seller for instruction. Manufacturer is not responsible for any damage and consequent damage by Misusage.
- The charger is designed for indoor use only.
- Don't leave the charger unattended during charging.
- The Charger should be horizontally positioned and work in well ventilated condition, avoid wet and keep it away from inflammable explosive goods.
- Don't cover the charger when charging, ambient temperature shall not be more than 40oC
- Don't touch the plug.
- Don't leave the batteries and chargers on wood surface or carpet.
- Cut off the power supply before connect or disconnect the charger with batteries.
- Don't try to disassemble the charger, High voltage inside, danger!
If you need a high-quality battery charger for your NiMH / NiCd battery packs, the Tenergy 01005 Smart Universal Battery Pack Charger is the product for you. This 12V battery charger is the best charger on the market for charging RC Car, RC Air and Airsoft battery packs that are 7.2V 2000mAh battery packs, 8.4V units, 4 wire 9.6V battery packs and 12V battery packs respectively. Charging time is approximately three hours for 2000mAh battery packs and two hours for 3000mAh battery packs. Care must be taken when charging battery packs to damaging the charger and/or battery packs so thoroughly reading the Tenergy Universal Smart Charger Manual is advisable before charging your battery pack.